Sold out

TIDES

£185.00
  • TIDES

Tides is fundamentally a highly tweak-able dirty reverb. A more accurate description of the pedal would be an atmosphere generator that allows you to craft perfect noisy waves of reverb. Usually you would be advised to place all dirt before your reverb pedal but Tides ignores this convention and provides you with not one, but two gain-stages after your dry signal has been blended with the reverberated signal. This approach enables you to create over the top fuzzy walls of sound sprinkled with interesting harmonics and sonic artefacts that would not be achieved otherwise. When pressed, the momentary 'swell' foot-switch forces the pedal into self oscillation as the reverb signal is fed back into itself for wild washes of sound and feedback as and when you desire. The final trick up the pedals sleeve is an effects loop, which allows you to place any effect (or chain of effects) that you can imagine onto your reverberated signal to further expand the ability for sonic exploration and the discovery of new, unconventional sounds. The ultimate shoegazers wet dream.

SWITCHES:

Gain I
Engages the primary drive circuit which is a low gain, opamp based overdrive overdrive with soft silicon clipping.

Gain II
Adds a reverse transistor fuzz circuit to the end of your signal chain. This can be used in conjunction with the primary drive circuit for thick walls sound.

Dry Kill
Removes your dry signal from your signal path. Perfect for producing soundscapes and ambient washed out textures.

*note* This mode will introduce a slight delay when engaging the effect as the circuit requires a second for the signal to pass through the reverb brick.

KNOBS:

Gain
Adjusts the amount of gain for the primary drive circuit, this can be dialled back to provide a gentle clean boost or cranked for sweet saturation.

Tone
Adjusts the filter of the primary drive circuit. Dialling this tone knob back will cut the highs of your signal and leave a thick almost fuzz like tone to your drive, while turning the knob clockwise adds highs to give you clear and sharp tones.

Moisture
Blends in your reverberated signal with the your dry signal.

Swell
This knob is tied to the left momentary footswitch. When pressed the footswitch completes a feedback circuit which feeds the reverberated signal back into the reverb brick, this causes the circuit to regenerate to the point of oscillation. Fully clockwise the knob lets all of your signal feed back on itself, roll it back to tame the feedback!

Colour
This controls the tonality of the wet signal. Turn clockwise for clangy, treble-heavy spring reverb sounds. Turn anti clockwise for a thicker blanket of ambient reverb.

Master
Controls the overall output of the circuit.

*note* As this is a passive volume control it needs to be maxed out if both gain circuits are disengaged to provide unity volume

Effects Loop
Tides comes equipped with an effects loop which allows you to introduce whatever effects you would like to your wet signal. The only limit here is your imagination octave down verb? why not?! arpeggiated walls of noise? hell yes! envelope filtered explosions of fuzz? No problem.

9V 'BOSS style' DC adaptor only. No Batteries.

Please allow 3-4 days for despatch. Will happily ship worldwide.

Note: International orders may be subject to customs fees. All additional fees are buyer’s responsibility.

Every Holy Island Audio pedal is dreamt up, hand printed and hand built in Cardiff, Wales.

Sign up to my mailing list for updates on restocks, new pedals and promotions!